Your agricultural
parts connection

C and CFR Variety Effectiveness Information

C Form Flex-Flex Couplings
The C Form coupling includes two flex hubs, one particular sleeve and a single accessory kit consisting of seals and snap rings.
CFR Variety Flex-Rigid Couplings
The CFR Form coupling consist of a single flex hub, a single rigid hub, 1 sleeve, one accessory kit consisting of seals and snap rings.
Simple and low-cost variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Offered as vertical and horizontal couplings
Wide number of distinctive variations for instance full-flex, flex-rigid mill motor
Common configurations can be found of your shelf
Ordering Facts
Application: Driver and Driven.
Kind and dimension of coupling, horizontal, vertical etc.
Power: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
C and CFR Form Couplings
Ordering Info
Puller Holes are regular on sizes 4 by way of 12.
Puller Holes are available for sizes 7/8 by means of three.5 at an additional charge.
The BSE (distance Among Shaft Ends) may fluctuate concerning G and G1.
Interference bores without set screws are conventional unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Area.
Greater sizes are available, please seek advice from Technical Assistance.


Get In Touch

Interested in our products? Need some technical support? Just have a few questions? Feel free to contact us.

[contact-form-7 id=”57″ title=”Contact form 1″]

The use of original equipment manufacturer’s (OEM) part numbers or trademarks , e.g. CASE® and John Deere® are for reference purposes only and for indicating product use and compatibility. Our company and the listed replacement parts contained herein are not sponsored, approved, or manufactured by the OEM.