Power UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE one
Basic Description
This power unit is built solely for the little lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has become widely utilised from the market of logistic products for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed through the solenoid valve with all the speed controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This energy unit is made solely for that medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve along with the speed managed through the adjustable needle valve. When the lift rises to a large positoin, however the energy provide is cut, the lowering movement is controlled through the guide override perform.
Energy UNITS FOR LIFT TABLE three
Basic Description
This power unit is designed exclusively for the huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and the pace managed by a pressure compensated flow handle valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This electrical power unit is developed solely to the large lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as the velocity controlled by the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power supply is lower, the reducing movement is managed through the manual override perform.
Particular Notes
one. This power unit is of S3 duty cycle, which could only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned in advance of set up of the power unit.
3. Viscosity in the oil shoud be 15~46 cst,which must also be clean and cost-free of impurities.N46 hydraulic oil is proposed.
4. Oil altering is needed after the initial one hundred operation hours,afterwards when each 3000 hrs.
5. The electrical power unit proven is made to be mounted vertically.