Your agricultural
parts connection

SMR Gearbox Installation

SMR Gearbox Installation
Satisfactory overall performance is determined by good installation. lubrication and maintenance. for that reason it is vital the directions during the set up and maintenance leaflet. provided with every single gearbox. are followed very carefully. several of the significant elements of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as shut for the reducer possible, and mount reducer on driven shaft as shut to bearing as practical. failure to accomplish this can trigger extra loads inside the input shaft bearings and output bearings and could result in their premature failure.
two. Install motor and wedge belt drive with all the belt pull at about 90° for the center line concerning driven and input shafts. this will likely permit tensioning with the wedge belt drive with the torque arm which ought to preferably be in tension. if output hub runs anti-clockwise. torque arm needs to be positioned the appropriate.
3. lnstall torque-arm fulcrum on a rigid assistance in order that the torque-arm will likely be at approximately proper angles on the center line through the driven shaft as well as the torque arm case bolt. make sure there exists ample get up during the turnbuckle for belt stress adjustment.
Retain near.
Bell drive can be situated in any practical postion. in case the torque arm should be to be made use of to tighten the belts, the drive need to be at about tight angle to your line in between the input and output shafts.
Bell drive could possibly be situated to the suitable if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that proven in the illustration.
Torque arm and belt take up.
Torque arm can be mounted to your suitable if preferred.

Contacts

Get In Touch

Interested in our products? Need some technical support? Just have a few questions? Feel free to contact us.

[contact-form-7 id=”57″ title=”Contact form 1″]
X

The use of original equipment manufacturer’s (OEM) part numbers or trademarks , e.g. CASE® and John Deere® are for reference purposes only and for indicating product use and compatibility. Our company and the listed replacement parts contained herein are not sponsored, approved, or manufactured by the OEM.