Your agricultural
parts connection

Tractor Pto Shaft

The wrap point hazard isn’t the only hazard connected with IID shafts. Serious injury has occurred when shafts have become separated while the tractor’s PTO was involved. The machine’s IID shaft is normally a “telescoping shaft”. That’s, one area of the shaft will slide into a second part. This shaft feature offers a sliding sleeve which greatly eases the hitching of PTO powered devices to tractors, and enables telescoping when turning or moving over uneven ground. If an IID shaft is coupled to the tractor’s PTO stub but no different hitch is made between the tractor and the device, then your tractor may pull the IID shaft aside. If the PTO is usually involved, the shaft on the tractor end will swing Tractor Pto Shaft wildly and may strike anyone in selection. The swinging force may break a locking pin permitting the shaft to become a flying missile, or it may strike and break something that is fastened or mounted on the trunk of the tractor. Separation of the driveline shaft isn’t a commonly occurring celebration but is most probably to happen when three-point hitched products is improperly attached or aligned, or when the hitch between your tractor and the fastened machine breaks or accidentally uncouples.

On top of that, many work practices such as for example clearing a plugged machine brings about operator contact with operating PTO shafts. Various other unsafe methods include mounting, dismounting, reaching for control levers from the rear of the tractor, and stepping over the shaft instead of walking around the machinery. A supplementary rider while PTO electrical power machinery is functioning is another exposure scenario.

PTO power machinery may be engaged while no-one is on the tractor for many reasons. Some PTO powered farm apparatus is operated in a stationary job so the operator only requires to start and stop the equipment. Examples of this type of products contain elevators, grain augers, and silage blowers. At different times, adjustments or malfunction of equipment components can only just be produced or found as the machine is operating.


Get In Touch

Interested in our products? Need some technical support? Just have a few questions? Feel free to contact us.


    The use of original equipment manufacturer’s (OEM) part numbers or trademarks , e.g. CASE® and John Deere® are for reference purposes only and for indicating product use and compatibility. Our company and the listed replacement parts contained herein are not sponsored, approved, or manufactured by the OEM.